Hardware Support: OpenLCBThe support on this page is rapidly evolving; the actual code might be ahead or behind the documentation on any given day.
ConnectingJMRI provides support for general JMRI Sensors and Turnouts in terms of OpenLCB "events".
JMRI associates OpenLCB Events with individual JMRI
objects (Sensors, Turnouts, etc.) via the JMRI System Names.
A System Name like
MS184.108.40.206.220.127.116.11;18.104.22.168.22.214.171.124" defines a
Sensor that follows the "126.96.36.199.188.8.131.52" and
"184.108.40.206.220.127.116.11" OpenLCB Events to change state.
Another format for Event ID's is a continuous hexadecimal
string, such as "
These System Names can get very long, in which case the "User Names" become much more useful.
OpenLCB messages coming into JMRI applications can be
accessed via JMRI Sensor objects. The Sensor's System Name determines which OpenLCB Events
it corresponds to.
A Sensor is defined by two Events: The one that sets it ACTIVE, and the one that sets it INACTIVE.
The Event numbers are essentially arbitrary, and are defined by the OpenLCB Nodes that send them. Because Events are not intrinsically associated with specific hardware objects, and because people can use Event ID's in many ways, the specific Event ID's for a Sensor must be supplied.
You create Sensors using the Add... button on the Sensor Table. If you supply two event ID's, the first will set the Sensor ACTIVE and the second will set it INACTIVE. If you provide just one, it will set the Sensor ACTIVE, and it will automatically reset itself to INACTIVE shortly after. This can be used for events that indicate momentary things on the layout like "it's noon".
The scheme for Turnouts is similar to Sensors above,
except JMRI is emitting the OpenLCB frames instead of
receiving them, and the type letter is "T" instead of "S",
OpenLCB connection options are on a separate page.
JMRI OpenLCB Tools
When JMRI is connected to a layout via this system, an OpenLCB menu is shown:
- Traffic Monitor
- You can directly operate the OpenLCB network via the
Send Frame tool
- Browse and set Configuration with the
Configure Nodes tool
- Start Hub
Firmware Update tool can load new firmware into
compatible OpenLCB Nodes
- How to Connect JMRI to an OpenLCB installation
- The Help page on OpenLCB Technical Details
- The main Help page for JMRI CAN support, including links to various general tools